Page 2
Serial number: ___________________________________ Date of purchase: ________________________________ Place of purchase: ________________________________ Acer and the Acer logo are registered trademarks of Acer Incorporated. Other companies’ product names or trademarks are used herein for identification purposes only and belong to their respective companies.
Information for your safety and comrt Safety instructions Read these instructions carefully. Keep this document for future reference. Follow all warnings and instructions marked on the product. Special notes on LCD monitors The following are normal with the LCD monitor and do not indicate a problem. •...
and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should never be placed near or over a radiator or heat register, or in a built-in installation unless proper ventilation is provided.
We at Acer are very conscious of the environmental effects of our business and strive to identify and provide the best working procedures to reduce the environmental impact of our products.
For more information on the Waste from Electrical and Electronics Equipment (WEEE) regulations, visit https://www.acer-group.com/sustainability/en/our-products- environment.html LCD pixel statement The LCD unit is produced with high-precision manufacturing techniques. Nevertheless, some pixels may occasionally misfire or appear as black or red dots.
eyestrain. Eyes • Rest your eyes frequently. • Give your eyes regular breaks by looking away from the monitor and focusing on a istant point. • Blink frequently to keep your eyes from drying out. Display • Keep your display clean. •...
Page 8
(“x” = 0~9, a ~ z, A ~ Z, or blank) We, Acer Incorporated, hereby declare under our sole responsibility that the product described above is in conformity with the relevant Union harmonization legislations as below Directive and following harmonized...
Page 9
Acer America Corporation 333 West San Carlos St., San Jose Suite 1500 CA 95110, U. S. A. Tel : 254-298-4000 Fax : 254-298-4147 www.acer.com Federal Communications Commission Supplier's Declaration of Conformity This device complies with Part 15 of the FCC Rules. Operation is subject to the following...
Table of Contents Information for your safety and comrt ................ii Safety instructions .......................ii Special notes on LCD monitors ..................ii Cleaning your monitor ..................ii Accessibility ......................ii Safe listening ......................ii Warnings ......................ii Using electrical power ..................iii Product servicing ....................iii Potentially explosive environments ..............iv Additional safety information ..................iv IT Equipment Recycling Information ................iv Disposal instructions ....................iv...
Please check that the following items are present when you unpack the box, and save the packing materials in case you need to ship or transport the monitor in the future. DP Cable LCD monitor Quick start guide (Optional) X38 S USB cable HDMI cable AC Power cord (Optional) (Optional) X38 User Guide English...
You can also adjust the monitor’s height within +/- 130 mm. Disassembly Velcro Note: Velcro is used to prevent height adjustment burst and hurting people! Height Adjustment 130mm Note: Please adjust the height of the monitor afer pressing the top of the monitor. X38 User Guide English...
Reconnect the cables. Refer to the user's manual that came with the optional wall mounting arm for instructions on attaching it to the wall. Note: VESA mounting screw holes are not available for all models, please check with the dealer. X38 User Guide English...
Connect the USB 3.0 cable to port. Insert the monitor power cable into the power port at the back of the monitor. Plug the power cords of your computer and your monitor into a nearby electrical outlet. X38 User Guide English...
Page 16
HDMI 1 HDMI 2 DP IN Reflex Latency analyzer Note: • Audio output is only for audio output model. Please check user manual for more instruction. • Charging USB devices just in DC on mode. X38 User Guide English...
The power saving states will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from Active OFF state back to ON state is around 3 seconds. X38 User Guide English...
Information Hot Key : Show Monitor Information and Reset control function. Modes Hot Key : To change Modes Hot Key menu. Exit Hot Key : To exit current page and store. X38 User Guide English...
Page 22
Off: Use fixed value. On: Use automatic value guided by light sensor. Default is: On 12. Max Brightness Default: OFF Off: Lower brightness On: Restore original brightness. When “Max Brightness” be changed, “Modes” will be reset to “Standard”. X38 User Guide English...
Page 23
Toggle the joystick to the up or down to select Audio from the OSD.Then toggle to the right to navigate to the element you wish to adjust and press the joystick to enter it. Toggle to the left or right to adjust the sliding scales. X38 User Guide English...
Page 24
Reflex Latency Analyzer works by detecting the clicks coming from your mouse and measuring the time it takes for a resulting display pixel change (i.e. gun fire) to happen on the screen, providing you with a full System Latency measurement. X38 User Guide English...
Page 25
• In normal display condition to press the "Navi Key" in the middle of more than 3 seconds to trigger "OSD Unlock". • The "OSD Unlock" message will be displayed in the middle of the screen. X38 User Guide English...
Page 26
Save Setting to Game mode: There are three user-defined profiles available. When you have decided what settings suit you, save them and system will be able to recall the settings in the future when you turn on gaming mode . X38 User Guide English...
Check if the video signal cable is properly connected at the back of monitor. Check if the computer system is switched on and in power saving/standby mode. Note: Acer monitor is purposed for video and visual display of information obtained from electronic devices. Regulatory Compliance 217186 I.T.E.