Set Supervisor/User Password - MSI MS-6323 Manual

CHAPTER 3

3.12 Set Supervisor/User Password

You can set either supervisor or user password, or both of them. The
differences are:
Supervisor password : can enter and change the options of the setup
User password
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The
password typed now will clear any previously entered password from CMOS
memory. You will be asked to confirm the password. Type the password again
and press <Enter>. You may also press <Esc> to abort the selection and not
enter a password.
To disable a password, just press <Enter> when you are prompted to enter the
password. A message will confirm the password will be disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every
time you try to enter Setup. This prevents an unauthorized person from chang-
ing any part of your system configuration.
Additionally, when a password is enabled, you can also require the BIOS to
request a password every time your system is rebooted. This would prevent
unauthorized use of your computer.
menus.
: Can only enter but do not have the right to change
the options of the setup menus. When you select
this function, the following message will appear at
the center of the screen to assist you in creating a
password.
AWARD
3-32
BIOS SETUP
®