Table of Contents
Advertisement
2.3.4 VDSL MODEM WORK MODE CONFIGURATION
1． For different protocols, the users need to set VDSL Modem accordingly as listed below:
Table 2.2
ATM VC
PPPoE
√
PPPoA
√
Lower interface
1483 Bridged
√
Note: √ means configure according to VDSL service provider's instructed value.
PPPoE can also be realized via third party dialup software.
User Manual
PPPoE
Reference Chapter
3.3
2． After getting through every page for parameters set-up, click "Apply" to save the value in VDSL MODEM
3． Click the "Restore Default Settings" on "Management" Tab to enter the saving configuration page as
Figure 2.3. After the Modem reboot,The VDSL MODEM will work on the new parameters.
Figure 2.2
Protocol
Use DNS
PPPoE
Enable
PPPoA
Enable
Default route
Disable
PPPoA
3.3
- 9 -
VDSL2
User Name
√
√
1483 Bridged
3.2
Modem User Manual
Password
√
√
Advertisement
Table of Contents
