Table of Contents
Advertisement
modem.
2.
Connect Ethernet port of the VDSL MODEM to Ethernet port of the computer using the network cable that
comes with the modem.
3.
Connect USB port of the VDSL MODEM to USB port of the computer using the USB cable that comes
with the modem.
4.
Plug in the power cord , and turn on the power.
2.3 SOFTWARE CONFIGURATION
2.3.1 PREPARATION BEFORE SOFTWARE INSTALLATION
Before the installation, please confirm information below or consult with the VDSL service provider. Table
2.1 shows all the information needed to configure for different protocols.
Table 2.1
Protocol
PPPOE
Necessary
User name
Information
Password
2.3.2 COMPUTER CONFIGURATION
The default factory-set IP Address for the VDSL MODEM is: 192.168.1.1. The Subnet Mask is:
255.255.255.0. Users can configure VDSL MODEM through an Internet browser. VDSL MODEM can be used
as a gateway and DNS server and users need to set the computer's TCP/IP protocol as follow:
1.
Set the computer at same Internet segment with VDSL MODEM so as to enter VDSL MODEM
configuration page through a browser.
Set the computer's gateway's IP address the same as the VDSL Modem's.
2.
Set the computer's DNS server's IP address the same as the VDSL Modem's or that of an effective DNS
3.
server.
If the user has any question regarding the computer's TCP/IP protocol, please refer to APPENDIX C:
TCP/IP PROTOCOL CONFIGURATION.
2.3.3 VDSL MODEM CONFIGURATION
Open the browser; input http://192.168.1.1 in the address column. Press "Enter" key then the entry dialog
box will pop up as Figure 2.2, Input username: admin, and password: admin (Note that this is capital
sensitive), then press "Enter". The VDSL MODEM configuration page will be shown.
Virtual Dial Mode
PPPOA
VPI
VPI
VCI
VCI
User name
Password
Private Line Mode
1483 Bridged
VPI
VCI
- 8 -
VDSL2
Modem User Manual
Advertisement
Table of Contents
