Exmark PHAZER Setup Instructions

Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
109-3354 Dealer Literature Pack
Part # Description
103-1309 Warranty Registration Form
103-2106 Key, Exmark Ignition
1-603511 Key, Standard Ignition
3274-94 Screw, Button Head 3/8-16 x 1
1-373034 Washer
104-8301 Nut, Nyloc 3/8-16 Flg
109-3131 Literature Pack
Part # Description
106-7022 Tube, Oil Drain
109-4354 Manual, Operator's
109-4355 Manual, Parts
106-8294 Manual, Engine Operator's
Checking Tire Pressure
1. Check the tire pressure in the drive tires. Proper
inflation for drive tires is 13 psi (90 kPa).
2. Adjust if necessary.
Fasten Seat
1. Remove the nut, washer and bolt from the lanyard.
2. Tilt seat downward and align lanyard to the hole in
the side of the seat (See Figure 1).
3. Install washer, bolt and nut.
FIGURE 1
Rotate seat retention bracket as shown in Figure 2
4.
and tighten screw.
SETUP INSTRUCTIONS
Qty Use
1 Fill out and return to Exmark
1
Unit ignition
1
2
2 Installing Roller Bracket Assembly
2
Qty Use
1 Draining engine oil
1
Read and view before operating machine
1
1 For Units with Kawasaki Liquid Cooled Engines
PHAZER™
For Serial Nos. 600,000 and Higher
FIGURE 2
109-3910 Rev. B
Page 1 of 4