Hdmi Video Resolution - Sanyo FWBP507FF Owner's Manual

10.2. HDMI video resolution

HOME A "Setup" A "
Sets the resolution of the video signal output from the HDMI OUT jack.
C Set up resolution
1. Use [
2. Use [ ] to select "
3. Use [ ] to select "TV" , then press [OK].
4. Use [ ] to select "Resolution" , then press [OK].
5. Use [ ] to select your desired Setting, then press [OK]. On the confirmation screen, use [
"OK" , then press [OK].
6. Press [HOME] to exit.
C Set up HDMI 1080p/24Hz
1. Follow steps 1 to 3 in "Set up resolution" above on this page.
2. Use [ ] to select "HDMI 1080p 24Hz" , then press [OK].
3. Use [ ] to select "On" or "Off" , then press [OK].
4. Press [HOME] to exit.
You can select the desired "Resolution" among the settings listed below: "Auto", "480p", "720p", "1080i", "1080p".
Actual output resolution:
Setting in
"Resolution" "HDMI 1080p
Auto
480p
720p
1080i
1080p
EN
" A "TV" A "Resolution"
] to select "Setup" in the home menu, then press [OK].
" , then press [OK].
Setting in
480i/60
24Hz"
The highest resolution supported by your display device will automatically
be in effect.
On
* Images will be output in 1080p/24 when the connected device supports
1080p/24.
The highest resolution supported by your display device will automatically
be in effect.
Off
* Images will be output in 1080p/60 even if the connected device supports
1080p/24.
On
Off
On
Off
On
Off
On * Images will be output in 1080p/24 when the connected device supports
1080p/24.
Off * Images will be output in 1080p/60 even if the connected device
supports 1080p/24.
Source
480p/60 720p/60
480p/60
720p/60
1080i/60
1080p/60
1080p/60
38
1080i/60 1080p/60
continued on next page
] to select
1080p/24*