Installing and Removing the Card
The captured image is recorded onto the card (sold separately).
Make sure the card's write protect switch is set upward to
enable writing/erasing.
Installing the Card
Shots remaining
The shots remaining depends on the remaining capacity of the card,
image-recording quality, ISO speed, etc.
The [1 Shoot w/o card] menu option set to [Off] will prevent you from
forgetting to install a card. (p.108)
Open the cover.
1
Slide the cover as shown by the
arrow to open it.
Insert the Card.
2
As shown by the illustration, face
the card's label side toward you
and insert it until it clicks in place.
Close the cover.
3
Close the cover and slide it in the
direction shown by the arrow until it
snaps shut.
When you set the power switch to
<1>, the number of remaining
shots will be displayed on the LCD
monitor.
31