Table of Contents
Advertisement
You cannot install PCI Express devices in PCI slots. PCI Express devices support up-
plugging into a PCI Express slot of higher lane width. For more information, refer to
ni.com/pciexpress.
1. PCI Express Device
2. PCI Express System Slot
3. PC with PCI Express Slot
6.
Secure the module mounting bracket to the computer back panel rail.
7.
Replace any access panels on the computer case.
8.
Plug in and power on your computer.
9.
If applicable, install accessories and/or terminal blocks as described in the installation
guides.
10. Attach sensors and signal lines to the device, terminal block, or accessory terminals.
Verifying Hardware Installation
You can verify that the system recognizes the PCIe-7820R by using Measurement &
Automation Explorer (MAX).
1.
Launch MAX by navigating to Start»All Programs»National Instruments»MAX or by
clicking the MAX desktop icon.
2.
Expand Devices and Interfaces.
3.
Verify that the device appears under Devices and Interfaces.
If the device does not appear, press <F5> to refresh the view in MAX. If the device does
not appear after refreshing the view, visit
4 | ni.com | NI PCIe-7820R Getting Started Guide
Figure 2. Installing a PCI Express Device
2
1
3
ni.com/support
for troubleshooting information.
Advertisement
Table of Contents
