Installation Notes - Klarstein 10035779 Manual

Notes on ambient temperature
Install this unit in a location where the ambient temperature corresponds to the climate
class indicated on the unit's nameplate.
SN
Low
N Moderate
ST Subtropical
T Tropical

INSTALLATION NOTES

It is important that you leave your device upright for at least 4 hours before switching it
on to allow the cooling system to adjust.
• When you move the unit, do not tilt it more than 45 degrees. Do not apply force to
parts such as the condenser, door or handle. They can distort and interfere with the
operation of the cooler. Make sure ALL packaging is removed before installation.
• Make sure there is enough space around the product to allow air to circulate freely.
• Do not place the product near heat sources, in direct sunlight or in humid rooms.
• Make sure that the supply voltage of the power outlet corresponds to the voltage
indicated on the type plate.
• Insert the plug firmly into the socket.
• The socket outlet must be earthed. Do not plug the plug into unearthed sockets and
do not use an extension cable.
• The product is equipped with adjustable feet. Once the product is in place, adjust
them so that the refrigerator is level and does not slip.
Note: Do not place the product in places where the ambient temperature can fall
below 5 °C, e.g. in the garage or shed.
This cooling unit is designed for use at ambient
temperatures of 10-32 °C.
This cooling unit is intended for use at ambient
temperatures of 16-32 °C.
This cooling unit is intended for use at ambient
temperatures of 16-38 °C.
This cooling unit is intended for use at ambient
temperatures of 16-43 °C.
EN
19