Installation Instructions - Klarstein BEERSAFE SLIM Manual

EN
18
Special notes on efficient use
• The shelves have been pre-set to allow the most efficient use of energy.
• Use only the shelves provided by the manufacturer.
• Never block the holes in the shelves and do not use any other types of shelves
that have not been approved by the manufacturer, which may cause poor
cooling or increase energy consumption.

INSTALLATION INSTRUCTIONS

It is important that you leave your unit upright for at least 4 hours before
switching it on to allow the cooling system to adjust.
• When moving the unit, do not tilt it more than 45 degrees. Do not apply force
to parts such as the condenser, the door or the handle. These can deform and
impair the operation of the cooler. Ensure ALL packaging is removed before
installation.
• Make sure there is enough space around the product for the air to circulate
freely.
• Do not connect the device to sockets that are already connected to other
kitchen appliances.
• Make sure that the supply voltage of the socket corresponds to the voltage
specified on the rating plate.
• Plug the power plug securely into the wall socket.
• The socket must be earthed. Do not insert the plug into unearthed sockets
and do not use an extension cord.
• The product is equipped with adjustable feet. Once the product is in place,
adjust the feet so that the refrigerator is level and does not slip.
Note: Do not place the product where the ambient temperature can drop below
5 °C, e.g. in the garage or shed.