Installation Instructions - Klarstein SILENT VINO Manual

INSTALLATION INSTRUCTIONS

• Position the device so that the plug is accessible.
• Protect the device from direct sunlight.
• Do not place the device next to a heat-generating device.
• The device performs better at an ambient temperature of 16-32 °C. We
recommend turning off the device when the ambient temperature is below
10 °C.
• After plugging in the appliance, allow it to cool down for 2-3 hours before
placing drinks in the cooling compartment.
• Ventilation is very important for this type of thermoelectric cooler. The inner
circuit board is easy to break if the ventilation is poor.
• These models use a thermoelectric cooling system with automatic defrost
system, so manual defrosting is not required.
Power supply
The refrigerator must be plugged into a properly grounded outlet that conforms
to applicable national codes before operation.
Check the rating plate (located on the side of the device) to ensure that the voltage
and frequency are the same as those in your country. If not, do not insert the plug
into the outlet.
Ventilation
• At least 200 cm should be left for
3
ventilation.
• The distance between the wall and
the cooler side should be at least
20 mm.
• At least 50 mm should be left at
the rear for air flow.
• The air flowing through must not
be preheated.
• The entire cooling system must be
considered for ventilation.
EN
29