Table of Contents
Advertisement
Fresh Food Storage
(continued)
Hole cover and air duct
slide into grooves on
bottom of air outlet box.
Air Duct
Lower portion of
air duct slides up
or down.
Adjusting the Chilled Air Duct
Care and Cleaning
Damp objects stick to cold
metal surfaces. Do not touch refrigerated
surfaces with wet or damp hands.
Adjustable Chilled Air Duct
The Chilled Air Duct, which distributes cold air to the Meat Keeper drawer, can be
adjusted to accommodate repositioning of the shelf. However, the shelf has a limited
range of positions in which the Chilled Air Duct will reach.
Air Outlet Box
The Chilled Air Duct can also switch sides, should you wish to move the split
cantilever shelf. To change sides:
Hole Cover
• Remove the Meat Keeper drawer and shelf. Grasp the air duct near top and
slide toward you until duct is free from grooves.
• Slide off hole cover on opposite side. Insert the lip of the air duct in grooves of new
hole and slide back.
• Slide hole cover over original hole.
• Replace shelf and insert drawer.
The Wine Rack stores bottles of wine, or 2-
liter plastic bottles of juice or soda pop. To
install, slide the wine rack onto the shelf with
the curve facing in. To remove, slide the
wine rack out.
Keep your refrigerator and freezer clean to prevent odor build-up. Wipe up any spills
immediately and clean both sections at least twice a year. Never use metallic
scouring pads, brushes, abrasive cleaners or strong alkaline solutions on any surface.
Do not wash any removable parts in a dishwasher.
Always unplug the power cord from the wall outlet before cleaning. Turning
the refrigerator control to OFF does not disconnect power to the controls, light
bulb, or other electrical components.
Inside
Wash inside surfaces of the refrigerator and freezer with a solution of 2
tablespoons baking soda in 1 quart warm water. Rinse and dry thoroughly. Be sure
to wring excess water out of sponge or cloth before cleaning around the
controls, light bulb, or any electrical parts.
Wash removable parts such as shelves and drawers with baking soda solution or
mild detergent and warm water. Do not use harsh cleaners on these surfaces.
Rinse and dry thoroughly. Clean the door gaskets with mild suds, rinse with clear
water and wipe dry. Do not use razor blades or other sharp instruments which
can scratch the appliance surface when removing adhesive labels. Any glue left
from the tape or energy label can be removed with a mixture of warm water and
mild detergent, or, touch the residue with the sticky side of tape already removed.
Do not remove the serial plate.
Outside
Wash the cabinet and handles with warm water and mild liquid detergent. Rinse
well and wipe dry with a clean soft cloth. Do not use commercial household
cleaners, ammonia, or alcohol to clean handles.
Remove any dust or dirt from the front of the toe grille using a vacuum cleaner
with its dusting tool attachment. Remove the toe grille by pulling it straight out.
While the grille is removed, vacuum the backside of the grille and wipe with a
sudsy cloth or sponge. Periodically clean the condenser (black tubes and wires
beneath the refrigerator, behind the toe grille). Do not allow lint or dust to
accumulate on the coils. Insert a long handled brush or vacuum attachment between
(some models)
7
Advertisement
Table of Contents
