Wiring Process Diagram - Sharp 1-BIT AMPLIFIER SM-SX1 Service Manual

SM-SX1/SX1W
(1 BIT PWB)
Core mounting position
Nylon band
Fix the core to the aperture
using nylon band.
(Head inside)
After fixing the core, insert the 5P connector from
the digital PWB. (See Fig.-B.)
F i g - B
core
3 0 mm
core
3 0 mm
5P
Wind the 5P lead wire, as
shown, once around each
core . Mount the cores and
lock them. Then, insert the
connectors.
Place the core around the
position shown above.
Insert the 2P connector
from the inlet.
All manuals and user guides at all-guides.com
Figure 10-1

WIRING PROCESS DIAGRAM

Push in the core.
After processing the core, insert the 12P connector from
the terminal PWB.
(Microcomputer PWB CNP904) (See Fig.-A.)
Pull out the lead wires from above.
Press the lead wires wound around
the core toward the SP relay PWB.
Press the core to the terminal
board with the core stood.
Figure 10-2
Push in the core.
– 10 –
F i g - A
Place the core near the
connector.
Twist the 12P lead wire and wind it
around core once (near the connector).
Mount the core and lock it. Then, insert
the connectors.
Detail drawing of winding lead wire
around the core
Approx. 60mm
core
Wind once.
Tie with nylon band.
Wind the lead wire around the core
once. Mount the core and lock it.
Then, tie them together nylon band.