GFA-OOT
Service
Service Overview
As the gear wheels of the GFA module are exposed to hard wear it is important to regularly check their
condition. If any of the gear wheels are worn or damaged, all the gear wheels must be replaced. Needle
bearings are to be replaced if needed.
At regular intervals between the service, additional grease is to be supplied through the grease nipples.
Maintenance Instructions
Service Intervals and Actions
Interval
Daily
At least after every 30,000 tightenings
At least after every 250,000 tightenings
In case of wear-out parts or in case of faulty tightening
result
Preventive Maintenance
Cleaning the System
To clean the system, wipe carefully with a clean, smooth cloth.
Lubrication Instructions
Lubrication Instructions
Component
GFA module
EN
Recommended
Lubricant
Molykote Longterm 2 Plus
© Saltus Industrial Technique AB - 9839 1814 01
Action
■
Clean the GFA system
■
Inspect the system for any damage
■
Check all fastenings of the system
■
Run functional tests and listen for any abnormal
noise
■
Lubricate the system
■
Service interval for overhaul and preventive main-
tenance
■
Change the output socket gear
■
Change the wear-out parts
Quantity
Until excess grease emerges on
the output socket
Service
9