Wellis Coyote WB00375 Instruction Manual page 10

Pre-Operation Leak Testing
EN
1. Do not insert any tool into the valve outlet or safety relief valve. You
may damage the valve and cause a leak. Leaking propane may
result in explosion, fire, severe personal injury, or death.
2. If a leak is detected at any time, or you cannot stop a gas leak, im-
mediately close the tank's shut-off valve (gas supply from LP tank
to the Side burner) and call LP gas supplier or your fire depart-
ment.
3. Check all gas supply fittings before each use and each time the
gas supply cylinder is connected to the regulator. Have a qualified
service technician leak test the side burner any time a part of the
gas system is replaced.
Never attempt to attach this side burner to the self-contained LP gas
system. Do not use the side burner until leak testing has been com-
pleted.
Leak Testing for Valves, Hose and Regulator
1. NEVER smoke while leak testing.
2. Extinguish all open flames. Never leak test with an open flame.
3. Mix a solution of equal parts mild detergent or liquid soap and
water.
4. Turn all side burner control knobs to OFF.
5. Ensure that the connections from the regulator to the side burner
and tank are tight and secure (see picture).
6. Completely open LP tank valve by turning cylinder valve knob
counterclockwise (right to left). If you hear a rushing sound, turn
gas off immediately. There is a major leak at the connection.
7. If no rushing sound, brush soapy
solution onto areas where bub-
bles are shown in LP tank (see
picture).
8. If "growing" bubbles appear,
there is a leak. Close LP tank
valve immediately and retighten
connections.
9. Always close LP tank valve after
performing leak test by turning
cylinder valve knob clockwise.
bubble