Gree GWC09UB-K3DNXXA Owner's Manual page 14

Operation of Remote Controller
Combination of "+"
17
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked,
three times.
Combination of "MODE " and "-" buttons :
18
At unit OFF, press
19 Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
20 Combination of " TEMP " and "CLOCK" buttons : About 8℃
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start
Nixie tube on the remote controller displays "
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
℉
21
About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press.
★
Notes:
● This is a general use remote controller, it could be used for the air conditioners with multifunction;
For some function, which the model doesn't have, if press
controller that the unit will keep the original running status.
●
After putting through power, air conditioner will give out a sound and operation indicator
is ON (red indicator). You can operate the air conditioner through the remote controller.
●
At ON status, after each pressing button on remote controller, the signal icon "
will flash once.Air conditioner will give out a sound,which indicates the signal has been sent to air conditioner.
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
★ Notes:
●
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
●
If the remote controller will not be used for a long time, please
remove batteries to prevent batteries from leaking.
●
The operation should be performed in its receiving range.
●
It should be kept 1m away from the TV set or stereo sound sets.
●
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly,
replace the batteries.
and "-" buttons: About lock
is displayed. In this case, pressing any button,
" "
" - "
MODE
and buttons simultaneously to switch between
Replacement of Batteries
About switch between Fahrenheit and centigrade
Heating Function
" and a selected temperature of " 8℃ "
the corresponding button on the remote
11
blinks
and
℉
℃
8℃ Heating Function
.
" "
" on remote controller
Sketch map for
replacing batteries
.