Advertisement
2.
FRONT PANEL CONTROLS
The following controls are located on the front panel, from left to right.
• REV: This knob continuously adjusts the intensity of the organ reverb effect. This reverb is
completely independent of the one associated with the REV I and REV II buttons as described
below, and is available for the organ tones only. The length of the reverb can be adjusted with a
control knob located inside the organ.
• VENT PRESET A-B (small black unlabeled rocker above the VOLUME NORMAL/SOFT tab): This
toggles between the two presets (A & B) of the mini VENT. Each of the two presets can store
different values of five parameters (see the "mini VENT Programming" section).
• VOLUME NORMAL/SOFT: This tab reduces the volume of the organ, enabling a lower minimum
volume. On the Soft setting, the signal is properly equalized for a perfect simulation of the original
effect. The swell (expression) pedal does not completely reduce the organ volume to silence,
replicating the typical behavior of the vintage consoles, and the VOLUME NORMAL/SOFT tab
allows for the usual techniques by making use of the associated equalization, but if a more
modern "Volume to 0" behavior is preferred, it can be obtained by adjusting the corresponding
parameter to 0 through the external Programmer Unit or the free Editor software.
• VIBRATO SWELL: This tab adds the vibrato/chorus effect to the upper manual according to the
position of the VIBRATO AND CHORUS selector.
• VIBRATO GREAT: This tab adds the vibrato/chorus effect to the lower manual according to the
position of the VIBRATO AND CHORUS selector.
• VIBRATO AND CHORUS: This rotary selector selects the type of vibrato or chorus effect, which can
be applied to both manuals independently.
4
Advertisement
