Advertisement
PROCEDURE TO ULTRASONICALLY CLEAN YOUR OBJECT
1. Turn the unit Off for 1 Second and back on to reset the Temperature & Time
to 0.
2. Turn the Time Set Knob to the desired amount of minutes you would like
for cleaning your object(s). Note that most all objects will be thoroughly
cleaned in 15 to 30 minutes.
3. Turn the Temperature Knob back to your first selected temperature or
whatever temperature you are going to clean your object(s) at. Note that
this will show the temperature in the Temperature Display as you have
already heated up the solution.
4. If desired, turn On the Sweep Function (highly recommended) for the entire
cleaning time.
Note during cleaning; dO NOT use the degassing Function as it is not
needed during cleaning. This is why the programming in the ultrasonic unit
will NOT let the Sweeping Function and the degassing Function to work/
run at the same time.
5. Set the Cleaning Basket or Wire Rack into the tank.
6. Put the objects into the basket or hang from the wire rack to clean them.
7. After the unit has run for the allotted time you set, it will automatically shut
off. When this happens, all Function Key Indication Lamps (LED's) will shut
off but the bottom Main On/Off Switch Lamp. You can now shut the unit
completely Off by pushing the On/Off Switch and unplugging the unit.
SPECIAL INSTRUCTIONS
When you are cleaning objects that have air pockets in them, you may wish to
rotate the object you are cleaning a couple of times (under the water/cleaning
solution) to get these air pockets out before ultrasonic cleaning them.
do not put any object directly on the bottom of the tank to be cleaned – always
use the cleaning basket, wire rack or place it in a beaker filled with water/cleaning
solution while the beaker is being held in place by the beaker holder.
We do NOT recommend placing the lid on the unit during the cleaning process as
it is not needed during the cleaning process.
- 7 -
Advertisement
