List Of Messages - Canon XH A1S Instruction Manual

List of Messages

Message
CARD ERROR
CARD FULL
CHANGE THE BATTERY PACK
CHECK THE HDV/DV INPUT
CONDENSATION HAS BEEN DETECTED
COPYRIGHT PROTECTED
DUBBING RESTRICTED
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
HEADS DIRTY, USE CLEANING CASSETTE
INCORRECT TAPE SPECIFICATION
PLAYBACK IS RESTRICTED
INPUT SIGNAL NOT SUPPORTED
NAMING ERROR
NO CARD
NO IMAGES
PLAYBACK STD LOCKED INCOMPATIBLE
VIDEO INPUT
PLAYBACK STD LOCKED
PLAYBACK IS RESTRICTED
REMOVE THE CASSETTE
SET THE TIME ZONE, DATE AND TIME
TAPE END
THE CARD IS SET FOR ERASURE
PREVENTION
THE TAPE IS SET FOR ERASURE
PREVENTION
UNIDENTIFIABLE IMAGE
(in alphabetical order)
A memory card error occurred. The camcorder cannot record or play back the image.
The error may be temporary. If the message disappears after 4 seconds and
in red, turn the camcorder off, remove the card and reinsert the card. If
green, you can continue recording/playback.
No remaining capacity on the memory card. Replace with another card or erase images.
Battery pack is exhausted. Replace or charge the battery pack.
DV cable is not connected, or the connected digital device is turned off.
Condensation has been detected in the camcorder.
You attempted to dub a copyright protected tape. May also appear when an anomalous
signal is received during analog line-in recording, or during analog-digital conversion of a
copyright protected tape.
You attempted to play back a copyright protected tape.
Video heads are dirty. Clean the video heads.
You attempted to play back a tape recorded in a standard different than the one to which
the camcorder is set.
You attempted to input a video signal incompatible with the camcorder (for example 720p).
The folder and file numbers have reached their maximum value.
Memory card is not inserted into the camcorder.
No images are recorded on the memory card.
When the playback standard is already set in the camcorder, you attempted to input a
video signal in a standard different from that set.
When the playback standard is already set in the camcorder, you attempted to play back a
tape in a video standard different from that set.
Camcorder stopped operating to protect the tape. Remove the cassette and reinsert it.
You have not set the time zone, date and time. This message appears each time you turn
the power on until you set the time zone, date and time.
Tape reached the end. Rewind the tape or replace the cassette.
SD/SDHC memory card is set for erasure prevention. Replace the card or change the
position of the LOCK switch.
Cassette is protected. Replace the cassette or change the position of the protect switch.
Image is not recorded with JPEG compression, or with a compression not compatible with
the camcorder, or the image file is corrupted.
Explanation
flashes
–
changes to
–
16
86
144
86
86
143
–
86
–
26
–
86
107
25
28
–
26
142
–
139