Troubleshooting - Asko D5436 Operating Instructions Manual

Troubleshooting

Display Type of fault
Overfilling
Water outlet fault
Water inlet fault
Inlet valve leakage
1)
Turn off the machine with the main power switch and then turn it on again to clear the error message from the display.
Problem
The dishes are not clean.
Spots or films on the dishes.
The dishes have a sticky white/blue film.
Spots on stainless steel or silver.
Spots left after washing.
1)
1)
1)
1)
Possible causes
The spray arms do not rotate.
Old detergent. Detergent is a perishable
product.
Incorrect detergent dosage.
Dishwashing program too weak.
Dishes loaded incorrectly.
Glasses and cups have toppled over during
the program.
The filter is not correctly fitted.
Incorrect rinse aid dosage setting.
Too high temperature and/or too much deter-
gent can cause etching on crystal. Unfortu-
nately, this cannot be repaired, only prevent-
ed.
Rinse aid dosage setting too high.
Some foodstuffs, such as mustard, mayon-
naise, lemon, vinegar, salt and dressings,
can mark stainless steel if left for too long.
All stainless steel can cause spots on silver
if they come into contact during dishwashing.
Aluminium can also cause spots on dishes.
Lipstick and tea can be difficult to wash off.
Action
Call the service department.
See "Water remains in the dishwasher" in the table
below.
Check that the water tap is on.
Check whether dishwasher inlet hose is connected to
a pressure limiting valve (some pressure limiting valves
may restrict the supply of water to the dishwasher).
Turn off the water tap and call the service department.
Action
Remove the arms and clean them.
Check that the dishes are not blocking the
spray arms.
Avoid large packages.
Dose according to water hardness. Far too
much or far too little detergent results in
poorer dishwashing results.
Select a higher temperature or a more pow-
erful program.
Do not cover porcelain with large bowls or
the like. Avoid placing very tall glasses in the
corners of the baskets.
Place dishes to sit steady.
Screw the filter firmly into place. See the
section Care and cleaning.
See the sections Before washing for the first
time and Settings.
Wash crystal at a low temperature and with
a conservative amount of detergent. Contact
the detergent manufacturer.
Reduce the amount. See the sections Before
washing for the first time and Settings. If you
have very soft water, you may want to dilute
the rinse aid 50:50 with water.
Rinse off these types of foodstuffs if not
starting the dishwasher immediately. Why
not use the Rinse & Hold program.
Silver and stainless steel items should not
come into contact during dishwashing.
Use a detergent with a bleaching agent.
13