Table of Contents
Advertisement
INSTRUCTIONS FOR THE USER
1 Burner
2 Flame safeguard sensor
If you have a problem with the cooktop, check the table below. You may be able to solve the problem and this will save
you from paying for a service call. You will have to pay for a service call even in the warranty period if the problem is one
listed below
FAULT
Burner will not light
even though the
sparker is working.
No spark is obtained
when control knob is
activated
Flames uneven or
tending to lift
Flames not staying on
when knob released
Low heat, slow
cooking
Benchtop or knobs
overheating
Cooktop stainless
steel discoloured
Outer ring of wok
burner goes out
when set to low
If the above points have been checked and there is still a problem with the cooktop, please call the Service Centre.
3 Injector
4 Ignition spark plug
POSSIBLE CAUSES
Knob not held down long enough in 'High'
position for flame safeguard to engage
Gas supply valve turned off
Wrong knob turned
Port blockage in ignition area
Ignition spark plugs wet or dirty
Injector blocked
Electricity supply is disconnected or
switched off"
Ignition spark plugs wet or dirty
Flame ports blocked or wet
Burner incorrectly fitted
K n o b n o t h e l d d o w n l o n g e n o u g h
in 'High' position for flame safeguard
(where fitted) to engage
K n o b n o t s e t b e t w e e n ' H i g h ' a n d
'Low'
Dirt or spillage on flame safeguard
sensor (where fitted)
Incorrect cooking pot or pan being used
Incorrect cooking pot or pan used
Pot or pan not located on burner
properly
Pot or pan being is too large
This is not a failure. This is a function of the
dual wok burner to give a very low power
flame option
REMEDY
Repeat lighting procedure and hold knob down for 6
seconds in 'High' position (refer page 3)
Turn on gas supply to appliance
Ensure the knob you are turning corresponds to the
burner you want to light
Ensure that ports in ignition area are clean and dry
Dry or clean ignition spark plugs
Ensure the injector remains free of any foreign
material. If necessary, use a thin piece of wire to
clear the orifice.
Switch on electricity or check fuses
Dry or clean ignition spark plugs
Clean or dry flame ports
Ensure this component is fitted correctly
Repeat lighting procedure and hold knob
d o w n f o r 6 s e c o n d s i n ' H i g h ' p o s i t i o n
(refer page 3)
Knob MUST be set between these positions
Clean flame safe guard sensor tip
Refer to table page 3
Check table on page 3 for correct pot or pan to be
used
E n s u r e p o t o r p a n i s c e n t r a l l y l o c a t e d
on burner
Ensure pot sizes used are as per user manual
requirements. Clean with STEEL POWER (available
through spare parts).
No remedy - burner is functioning as intended
5
Advertisement
Table of Contents
