Cooktop Display Windows; Before Setting Surface Controls - Frigidaire Professional FPCF3091LF User & Care Manual

Cooktop power level display windows
The cooktop power level display features provide a digital
display for each of the heating positions located on the
cooktop. Power levels are easily controlled and monitored
using the window displays in combination with the
corresponding control touch pads.
Available power level settings
The cooktop control will display heat levels ranging from Hi
(Fig. 1) to Lo (Fig. 5) and OFF (Fig. 6).
The settings between 9.5 (Fig. 2) and 3.0 (Fig. 3) decrease
or increase in .5 increments. The settings between 3.0 (Fig.
3) and 1.2 (Fig. 4) are simmer settings which decrease or
increase in increments of .2 for more precision at lower
heat levels. Use the "Suggested power level settings
table" provided later in this section to determine the
correct setting for the type of food you are preparing.
Power level settings-induction cooking zones only
When setting either induction cooking zone to the highest
level, the display will show Pb (Power Boost) power level
for up to 10 minutes (See Fig. 7). After 10 minutes the
cooking zone will automatically lower to the Hi setting. The
Pb setting is only available immediately after activating a
cooking zone and pressing the
Hot surface window message (HE)
After using a radiant element or induction cooking zone the
cooktop may be very hot. After turning any of these
elements OFF, the cooktop may remain HOT for some time.
The corresponding HE (hot element - Fig. 8) message will
remain ON and turn OFF once that element position on the
cooktop has cooled sufficiently (Fig. 6).
Lockout window message ( - - )
The (- -) message will appear whenever the lockout
feature is active (See Fig. 9). Refer to the lockout
instructions for more details. When the Sabbath Day
feature is activated, the cooktop displays will show the
cooktop lockout " - - " messages.
IMPORTANT
The induction cooktop will not operate when the oven is
set for Sabbath mode. To set the Sabbath Day feature
for the oven, see Setting Oven Controls section.

BEFORE SETTING SURFACE CONTROLS

power level keypad.
Fig. 1
Fig. 3
Fig. 5
Fig. 7
Fig. 9
NOTE
When setting the size for all 3 bridge elements to heat
together, both the display windows for the left front and
left rear elements will display the set power level & hot
element message (for models with a bridge surface
element feature only).
Fig. 2
Fig. 4
Fig. 6
Fig. 8
13