Table of Contents
Advertisement
1,MFL67647015,영영 2019. 3. 8. 영영 1:56 Page 17
Energy saving cooling mode
This mode minimizes power consumption
during cooling and increases the set
temperature to the optimal level for a more
comfortable environment. The temperature
automatically settles at 22 °C (72 °F) if desired
temperature is below 22 °C (72 °F) The
temperature remains constant if it is above
22 °C (72 °F).
d
1. Press
to turn on the power on.
f
2. Press
repeatedly to select the cooling
operation.
b
3. Press
.
G
-
is displayed on the display screen.
NOTE
• This function may not be supported,
depending on the model.
Display screen brightness
You can adjust the brightness of the indoor unit
display screen.
\
1. Press
repeatedly to set the brightness
to the desired level.
NOTE
• This function may not be supported,
depending on the model.
Operating the air conditioner
without the remote control
You can use the On/Off button of the indoor
unit to operate the air conditioner when the
remote control is unavailable.
Restarting the air
conditioner automatically
When the air conditioner is turned on again
after a power failure, this function restores the
previous settings. This function is a factory
default setting.
Disabling auto restart
1. Press the ON/OFF button and hold it for 6
seconds, then the unit will beep twice and
the lamp will blink twice 4 times.
Signal
receiver
Front Panel
ON/OFF button
Air Discharge
- To re-enable the function, press the On/
Off button and hold it for 6 seconds. The
unit will beep twice and the lamp will blink
4 times.
* The feature can be changed according to
type of model.
NOTE
• If you press and hold the On/Off button for 3
~ 5 seconds instead of 6 seconds, the unit
will switch to the test operation. In the test
operation, the unit blows out strong air for
cooling for 18 minutes and then returns to the
factory default settings.
EN
Air Filter
17
Advertisement
Table of Contents
