Advertisement
OVEN DOOR REMOVAL AND REPLACEMENT
To Remove the Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on each hinge supports and engage it in the
hinge lever. You may have to apply a little downward pressure on the
door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward
you to disengage the hinge supports. Keep pulling the bottom of the
door toward you while rotating the top of the door toward the range to
completely disengage the hinge levers.
To Replace the Oven Door:
1. Grab the door by the sides; place the hinge
supports in the hinge slots. Open the door to
the fully opened position.
2. Disengage the lock from the hinge levers on
both sides.
Note: Make sure the hinge supports are fully
engaged before unlocking the hinge levers.
3. Close the oven door.
The door is heavy. After removing
door, lay it flat on the floor with the inside of the
door facing down.
DOOR LOCK MECHANISM
The appliance is equipped with an electronic oven control
and has an auto locking door latch feature. When the self
clean cycle is programmed, the door is locked by a motor
operated latch system. The interior of oven doesn't need to
heat up to 500°F/260°C before the door locks. However, until
the temperature inside oven reaches 500°F/260°C, the self-
clean program can be canceled and door will unlock
immediately. After oven reaches temperatures over 500°F/
260°C, the door will not unlock until temperature drops
below 500°F/260°C.
If a problem appears and the door stays locked it is possible
for the servicer to unlock the door without removing the
appliance from its place. Follow the steps below:
1. Trip the circuit breaker to OFF position.
2. Remove the 2 screws, which are fixing the oven door latch,
located between the control panel and the oven door.
3. When the screws are removed it is possible to unlock the latch with
a flat screwdriver, or one of the tools supplied with the wall oven
which are used to take off the oven from the cabinet. Insert the tool
tip through the slot on top of the oven door. During this step it's
important to take care to not damage the appliance.
4. As soon as the latch is in the unlock position, you can open the door.
5. Replace the motor latch:
1.To have access to the door latch assembly, remove the 3 screws under the control panel which are fixing it.
2.Remove the access plate located on the upper air channel by removing the screw.
3.Replace the motor latch by a new one and reassemble in reverse order.
Lock engaged for door
removal
Motor Cooling Fan
Upper Air Channel
Safety
Thermostat
4
Hinge
lever
Hinge
support
Lock in normal position
HINGE SLOT -Door removed
from the range
Access Plate
Door
Locking
Mechanism
Assembly
Advertisement
