Table of Contents
Advertisement
Quick Links
DIGITAL FULL COLOUR MULTIFUNCTIONAL SYSTEM
Safety Guide
Safety Guide
Safety Guide
Before installing this product, be sure to read the
"CAUTIONS" and "INSTALLATION
REQUIREMENTS" sections.
Keep this manual close at hand for reference
whenever needed.
MODEL:
CAUTIONS
INSTALLATION REQUIREMENTS
SUPPLIES
SPECIFICATIONS
TO THE ADMINISTRATOR OF THE MACHINE
MX-2600G
MX-2600N
MX-3100G
MX-3100N
Advertisement
Table of Contents
Related Manuals for Sharp MX-2600G
Summary of Contents for Sharp MX-2600G
- Page 1 MODEL: MX-2600G MX-2600N MX-3100G MX-3100N DIGITAL FULL COLOUR MULTIFUNCTIONAL SYSTEM Safety Guide Safety Guide Safety Guide Before installing this product, be sure to read the "CAUTIONS" and "INSTALLATION REQUIREMENTS" sections. CAUTIONS INSTALLATION REQUIREMENTS SUPPLIES SPECIFICATIONS TO THE ADMINISTRATOR OF THE MACHINE Keep this manual close at hand for reference whenever needed.
- Page 2 Caution! For complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. Shielded interface cables must be used with this equipment to maintain compliance with EMC regulations. ➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢ Required in IEC-950 (EN 60 950) - Europe •...
- Page 3 FAX interface cable and Line cable: These special accessories must be used with the device. The Declaration of Conformity can be viewed at the following URL address. http://www.sharp.de/doc/MX-FXX2.pdf Important Notice for New Zealand Users General "The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network.
-
Page 4: Table Of Contents
• Aside from instances provided for by law, SHARP is not responsible for failures occurring during the use of the product or its options, or failures due to incorrect operation of the product and its options, or other failures, or for any damage that occurs due to use of the product. -
Page 5: Cautions
To prevent the loss of important documents in the unlikely event of a hard drive failure, keep the originals of important documents or store the original data elsewhere. With the exception of instances provided for by law, Sharp Corporation bears no responsibility for any damages or loss due to the loss of stored document data. -
Page 6: Laser Information
CAUTIONS Laser information Wave length 790 nm ±10 nm Pulse times 4.6 µs ±4.6 ns /7 mm (North America and Europe) Output power Max 0.6 mW (LD1+LD2) Caution Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This Digital Equipment is CLASS 1 LASER PRODUCT (IEC 60825-1 Edition 1.2-2001) For North America: SAFETY PRECAUTIONS... -
Page 7: Installation Requirements
INSTALLATION REQUIREMENTS Improper installation may damage this product. Please note the following during initial installation and whenever the machine is moved. 1. The machine should be installed near an accessible power outlet for easy connection. 2. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. -
Page 8: Supplies
Standard supplies for this product that can replaced by the user include paper, toner cartridges, and staple cartridges for the finisher. Be sure to use only SHARP-specified products for the toner cartridges, finisher staple cartridge, saddle stitch finisher staple cartridge, and transparency film. -
Page 9: Specifications
(21 lbs.)) 500 sheets, heavy paper 200 sheets Paper types: SHARP-recommended plain paper, recycled paper, coloured paper, and heavy paper * First copy out time is measured with original on the document glass in full ready condition with fuser at operating temperature and mirror motor at operating speed in each of black and white mode and colour mode, actual time may vary based on environment conditions. - Page 10 209 g/m (28 lbs. bond to 110 lbs. index)) Paper types: SHARP-recommended plain paper, recycled paper, coloured paper, and heavy paper Output method: Face-down output (A3W and 12" x 18" paper can be output to right tray, finisher, or saddle stitch finisher) Output capacity: 500 sheets (using SHARP-recommended A4 or 8-1/2"...
-
Page 11: Continuous Copying Speeds
SPECIFICATIONS Continuous copying speeds* Model MX-2600G/MX-2600N MX-3100G/MX-3100N Copy ratio 100% / Reduced / Enlarged Copy mode Colour copying Black and white copying Colour copying Black and white copying A3, 11" x 17", 8K 13 copies/min. 13 copies/min. 14 copies/min. 14 copies/min. -
Page 12: Acoustic Noise Emission
Standby mode MX-2600G/MX-2600N: 5.8 B MX-3100G/MX-3100N: 5.8 B Sound pressure level L (actual measurement) MX-2600G/MX-2600N Colour: 51 dB (A) Black and white: 51 dB (A) Bystander positions MX-3100G/MX-3100N Colour: 51 dB (A) Black and white: 51 dB (A) Printing mode... -
Page 13: Exit Tray Unit (Right Tray) Specifications
Output method Face-down output Output capacity* 100 sheets (using SHARP-recommended A4 or 8-1/2" x 11" paper) When tray is folded up: 289 mm (W) x 405 mm (D) x 52 mm (H) (11-3/8" (W) x 15-61/64" (D) x 2-3/64" (H)) -
Page 14: Stand/2X500 Sheet Paper Drawer Specifications
500 sheets (80 g/m (21 lbs.)) x 2 tray Paper types SHARP-recommended plain paper, recycled paper, and coloured paper When "Auto-AB" detection is selected: Automatic paper size A3, B4, A4, A4R, B5, B5R, 216 mm x 330 mm (8-1/2" x 13") detection When "Auto-Inch"... -
Page 15: Finisher Specifications
SPECIFICATIONS Finisher specifications Model MX-FNX9 A3W, A3, B4, A4, A4R, B5, B5R, A5R, envelopes, 12" x 18", 11" x 17", 8-1/2" x 14", Paper sizes 8-1/2" x 13-1/2", 8-1/2" x 13-2/5", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, 7-1/4" x 10-1/2"R, 5-1/2"... -
Page 16: Saddle Stitch Finisher Specifications
SPECIFICATIONS Saddle stitch finisher specifications* Model MX-FN10 A3W, A3, B4, A4, A4R, B5, B5R, A5R, envelopes, 12" x 18", 11" x 17", 8-1/2" x 14", 8-1/2" x 13-1/2", Paper sizes 8-1/2" x 13-2/5", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, 7-1/4" x 10-1/2"R, 5-1/2" x 8-1/2"R, 8K, 16K, 16KR Thin paper (55 g/m to 59 g/m... -
Page 17: Punch Module Specifications (For Finisher)
SPECIFICATIONS Punch module specifications (for finisher) Model MX-PNX1A MX-PNX1B MX-PNX1C MX-PNX1D Hole punching 2 holes 2 holes or 3 holes 4 holes 4 holes, broad width A3, B4, A4, A4R, B5, 2 holes: A3, A4 A3, B4, A4, A4R, B5, B5R, 11"... -
Page 18: Printer Specifications
*1 The standard printer driver of MX-2600G/MX-3100G. *2 When MX-2600G/MX-3100G are used, the printer expansion kit is required. *3 When the PS3 expansion kit is installed and the machine is used as a PostScript printer. -
Page 19: Network Scanner / Internet Fax Specifications
Scan to E-mail / Scan to FTP / Scan to Desktop / Scan to Scan destinations Network Folder *1 When MX-2600G/MX-3100G are used, the network scanner expansion kit is required. *2 Internet fax expansion kit is required. *3 When MX-2600G/MX-3100G are used, the automatic document feeder is required. -
Page 20: Facsimile Specifications
SPECIFICATIONS Facsimile specifications Model MX-FXX2 Applicable telephone line Public switched telephone network, PBX Scanning resolution 8 x 3.85 lines/mm (Standard), 8 x 7.7 lines/mm (Fine, Fine-Halftone), 8 x 15.4 lines/mm (Super Fine, Super Fine - Halftone), 16 x 15.4 lines/mm (Ultra Fine, Ultra Fine - Halftone) (supports ITU-T standards) Transmission speed... - Page 21 Information that the administrator of the machine requires is printed on the back of this page. (Separate this page from the manual and keep it in a safe place. In addition, fill in the name of the administrator and the administrator's contact information in the left hand margin.)
-
Page 22: To The Administrator Of The Machine
TO THE ADMINISTRATOR OF THE MACHINE (Separate this page from the manual and keep it in a safe place.) Factory default passwords When accessing the system settings, the administrator password is required to log in with administrator rights. The system settings can be configured in the Web pages as well as on the operation panel. To access the system settings using the Web pages, a password is also required. -
Page 23: For The Users Of The Fax Function
TO THE ADMINISTRATOR OF THE MACHINE For the users of the fax function Important safety instructions • If any of your telephone equipment is not operating properly, you should immediately remove it from your telephone line, as it may cause harm to the telephone network. •... - Page 24 TO THE ADMINISTRATOR OF THE MACHINE NOTICE FOR USERS IN AUSTRALIA AND NEW ZEALAND Your fax machine and the telephone system WARNING NOTICE: NO calls can be made to or from this fax during a mains power failure. WARNING Australian Communications Authority (ACA) regulations state that no unauthorized changes or modifications to this equipment are permitted.
-
Page 25: Trademark Acknowledgments
• IBM, PC/AT, and PowerPC are trademarks of International Business Machines Corporation. • Sharpdesk is a trademark of Sharp Corporation. • Sharp OSA is a trademark of Sharp Corporation. • RealVNC is a trademark of RealVNC Limited. • All other trademarks and copyrights are the property of their respective owners. - Page 27 SHARP ELECTRONICS (Europe) GmbH Sonninstraße 3, D-20097 Hamburg...
- Page 28 PRINTED IN CHINA This manual has been printed using a vegetable-based soy oil ink 2008G to help protect the environment. TINSE4019FCZZ...