Advertisement
"Telecommunication Products to solve
CK-1P6 Installed on
Telecommunication Problems"
KX-TG9391 Phone
CK-1P6
Promotion-On-Hold
Module
(For Panasonic KX-TG9391T, KX-
TG9392T, KX-TG9381, KX-TG9382)
3/14/13
Introduction
Thank you for purchasing the Skutch CK-
1P6 Promotion-On-Hold Module. The
Power Cube
1/8" Audio Adapter
CK-1P6 is a true plug and play device. The
unit does not require any "Learning" to
CK-1P6
operate. When a call is placed ON HOLD
Box
from the Corded Base set, or any one of the
cordless phones, the caller will hear the
Promotion-On-Hold audio. When the line is
re-answered, the audio automatically stops.
Flat Cable
It's that simple!
Audio Cable (RCA)
Installation
Sensor Board
1- Position the CK-1P6 box under the base
telephone with the jacks facing towards the back of the phone. (See Fig. 1).
2- Connect the short modular cord [1&2 Phone on CK-1] to [LINE 1/2 on Phone].
3- Connect the audio cord from the AUDIO IN jack on the back of the CK-1 box, to your
audio player. If your audio player has a 1/8" phone jack, use the audio adapter on the end
of the cable.
4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1].
Page 1 of 4
Advertisement
Table of Contents
Related Manuals for SKUTCH CK-1P6
Summary of Contents for SKUTCH CK-1P6
- Page 1 Thank you for purchasing the Skutch CK- 1P6 Promotion-On-Hold Module. The Power Cube 1/8” Audio Adapter CK-1P6 is a true plug and play device. The unit does not require any "Learning" to CK-1P6 operate. When a call is placed ON HOLD...
- Page 2 Fig #1 LINE 1/2 LINE 2 Connect to Wall Jack Connect to AudioPlayer 5- Make sure that the surface area of the base phone, where the sensor board is to be mounted, is clean and free of all dust and oil film. Peel off the paper protectors from the bottom of the sensor board, and place it OVER the LINE 1 and LINE 2 buttons on the Base phone as shown in Fig.
- Page 3 • ONE YEAR LIMITED WARRANTY This SKUTCH PRODUCT is warranted against defects for a period of one (1) year from the date of the original invoice. Within this period, we will repair it without charge for parts and labor. To obtain warranty service the product must be returned, at the customer's expense, to SKUTCH Electronics along with a copy of the original invoice.
- Page 4 ACTA Statement This equipment complies with Part 68 of FCC rules and the requirements adopted by ACTA. On the bottom side of this equipment is a label that contains, among other information, a product identifier in the format US: AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
Need help?
Do you have a question about the CK-1P6 and is the answer not in the manual?
Questions and answers