Advertisement
"Telecommunication Products to solve Telecommunication Problems"
CK-1P5 Installed on Phone
CK-1P5
Promotion-On-
Hold Module
For the Panasonic KX-TS4100,
KX-TG4200, and KX-TGS4300
Phones
1/8/2014--V4
Introduction
Thank you for purchasing the
Skutch CK-1P5 Promotion-
On-Hold Module for the
Audio Cable
Panasonic KX-TGS4100, KX-
(RCA to RCA)
TG4200, and KX-TS4300 four
Power Cube
line phone family. The CK-
3.5mm to RCA Adapter
1P5 works ONLY with these
three phone models. The CK-
CK-1 Box
1P5 is a true plug and play
device. The unit does not
require any "Learning" to
operate. When a call is placed
ON HOLD from any one of the
Flat Cable
phones, the ON HOLD caller
will hear the Promotion-On-
Hold audio. When the line is
Sensor Board
re-answered, the audio
automatically stops. The CK-
1P5 requires an external Audio player to supply the audio.
Installation
The CK-1P5 can be installed on any one telephone, and it will work from all phones that
are within the family (The 3 Models ONLY).
1- Make sure that the surface on the telephone is clean and free of dust and/or oil.
Page 1 of 4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SKUTCH CK-1P5
Summary of Contents for SKUTCH CK-1P5
- Page 1 1P5 requires an external Audio player to supply the audio. Installation The CK-1P5 can be installed on any one telephone, and it will work from all phones that are within the family (The 3 Models ONLY). 1- Make sure that the surface on the telephone is clean and free of dust and/or oil.
- Page 2 2- Peel the paper protector off back side of the "SENSOR BOARD" . Carefully align as shown in the picture below. The Sensor Board will almost snap into place, as it is designed to fit the contour of the phone. The Sensor Board will completely cover the Line 1 through 4 buttons on the phone.
- Page 3 2- Repeat this test for lines 2-4. If all lines light up when picked up, the CK-1 is working properly. If the lights on the SENSOR BOARD do not light up, then a) Make sure that the CK-1P5 and Phone is connected to power. b) Make sure that the SENSOR BOARD is aligned properly.
- Page 4 Lights on CK-1 Box. When you place a line on HOLD, the corresponding LED on the rear of the CK-1P5 box lights up to confirm the Promotion-On-Hold condition. Using Other Brand Phones with the KX- TS4100/4200/4300 Phones This family of phones is not compatible with other makes and models of telephones.
Need help?
Do you have a question about the CK-1P5 and is the answer not in the manual?
Questions and answers