Preparing For Use - Cortex HDTT-5000 Operation Manual

HDTT-5000 Operation Manual
All manuals and user guides at all-guides.com
Preparing for Use/Master Slave opperation
STEP ONE
Connect the Power Cord to the power outlet., found on the rear of the
unit.
STEP TWO
Connect the RCA audio outputs of the unit to a suitable audio mixer.
When connecting the unit, make sure you note that the MASTER outputs
carry audio from the MASTER or MAIN deck, and SLAVE outputs carry Fig 1.1 - Connect Power
audio from the SLAVE or AUX deck.
Note: When in SLAVE mode the outputs of the SLAVE unit will not operate
instead all outputs are routed through the MASTER
unit.
Fig 1.2 - Connect Audio
CONNECT TO MIXER
STEP THREE
Connect your primary USB device to the port found to the right of the
rear panel. You may choose any driverless device that follows FAT32,
NTFS, or HFS+ file systems. You may also connect a powered (active)
USB hub to augment the amount of available ports.
STANDARD USB CABLE
(Not Included)
SWITCH TO "S"
SWITCH TO "M"
If you wish to link 2 HDTT-5000s together, select the unit you desire to
be Master, flip the Master/Slave switch to "M", then power on. Do the
same for the unit that you wish to slave off the unit, only select "S" on
the Slave unit. Connect a standard USB cable to the chain link OUT
port on the MASTER and then to the chain link IN port on the SLAVE.
Then connect the audio outputs for both units to the Master unit.
SLAVE
MASTER
Fig 1.4 - Master/Slave Connection
Fig 1.3 - Connect USB
STEP FOUR
Press and Hold the Power button located in the center of the front panel
for about 1-2 seconds. The unit will take about 5-10 seconds to boot up
as well as detect any USB devices that are currently connected.
Fig 1.5 - Turn Power ON 10