Using The Dmix-300; Preparing For Use - Cortex DMIX-300 Product Manual

Dmix 300 Manual
All manuals and user guides at all-guides.com

Preparing for Use

STEP ONE
Connect the DC adapter to the DC Inlet, found on the rear of the unit.
Fasten the Security Clamp (found directly below the DC Inlet jack) on top
of the cable, so that it is not possible for the cable to become dislodged.
Fig 1.1 - Connect Power
STEP TWO
Connect the Master output to your main mixing board, amplifier or pow-
ered speakers using RCA cables. If you have a sperate booth monitoring
system, connect that to the Booth output. Connect the Record out to any
recording device you wish to use.
Fig 1.2 - Connect Audio
STEP THREE
Connect your primary USB device to the port found in the center of the
rear panel. You may choose any driverless device that follows FAT32,
NTFS, or HFS+ file systems. You may also connect a powered (active)
USB hub to augment the amount of available ports. . If you are using the
unit as a dock to connect to a PC with your Ipod, set the switch beside
the USB Type B connector to "Dock".
Fig 1.3 - Connect USB
STEP FOUR
Press and Hold the Power button located in the center of the front panel
for about 1-2 seconds. The unit will take about 5-10 seconds to boot up
as well as detect any USB devices that are currently connected.
Fig 1.4 - Turn Power ON
10