LG LCG3011BD Service Manual page 41

3. ADJUST THE SURFACE BURNER LOW FLAME (SIMMER) SETTING
For all surface burners except for the center burner
A. Light all surface burners except for the center burner.
B. Turn the knob on the burner being adjusted to "LO"(LOW).
C. Remove knob.
D. Insert a small, flat bladed screwdriver into the valve stem.
E. Turn the adjustment screw until the flame reaches the desired size.
F. Replace the knob.
G. Test The Flame Stability.
Test 1:
• Turn the knob from "HI" to "LOW" quickly.
• lf the flame goes out, increase the flame size and test again.
Test 2:
• With the burner on a "LOW" setting, open and close the oven or cabinet door quickly.
• If the flame is extinguished by the air currents created by the door movement, increase the
flame height and test again.
H. After low flame setting, turn off the burner.
I. Disconnected power to appliance.
J. Remove the cooktop plate.(See "Cooktop Plate".)
K. Reposition center LED lamp module by hooking.
L. Reposition cook top and secure all screws of cook top.
M. Reposition burner heads, burner caps, grates and knobs.
N. Connect power to appliance.
4. CONVERSION STICKER
Upon completion of conversion, fill out the LP sticker located with the instructions. Once
complete, apply the sticker to the back of the cooktop near the regulator. If converting back to
the natural gas from LP, remove the LP sticker from the back of the cooktop.
To convert to the original gas.
Follow conversion process with original orifices to convert the appliance to the original gas.
LGE Internal Use Only
CONVERSION TO LP GAS
-41- Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes