Single Burner Valve - LG LCG3011BD Service Manual

Single Burner Valve

WARNING
• DISCONNECT power supply before servicing.
• SHUT OFF gas supply to the cooktop before
sevicing.
• Replace all panels and parts before operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal injury, death
or electrical shock.
CAUTION
• Be careful when you work on the Cooktop
handling the sheet metal part.
• Check that the gas seal gasket on the
screw and the gas valve remain in place
before installing the new gas valve.
1. Remove the cooktop plate.(See "Cooktop Plate".)
2. Remove the LED lamp module.(See "LED Lamp Module".)
3. Remove the ignition switch assembly. (See "Ignition Switch Assembly".)
4. Remove the inch tubing from the gas valve outlet.
1
/
2
① Left Front Burner Valve ② Left Rear Burner Valve
(Violet)
Burner Valve
5. Unfasten the -in. hex head screw that holds
1
/
2
the burner valveto the gas manifold the burner
valve to the gas manifold.
1
/ -in. hex head crew
4
When replacing this part with new one, progress reversely.
LGE Internal Use Only
COMPONENT REPLACEMENT
③ Center Burner Valve
(Green) (R ed)
1
/ -in. Nut
2
Manifold
Buner Valve
Screw Seal
Valve Screw
Valve Seal
Single Burner valve
④ Right Front Burner Valve
(Blue)
Pipe(Tube)
6. Remove the burner valve.
-32- Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
⑤ Right Rear Burner Valve
(Yellow)
1
/ -in. Open-End Wrench
2