Table of Contents
Advertisement
BURNER
Auxiliary
14.6 Gas burners for LPG G30 28-30 mbar
BURNER
NORMAL
POWER kW
Triple
Crown
Rapid
Semi-rapid
Auxiliary
14.7 Gas connection
The gas pipe in the appliance has two
endings. You can connect the gas supply
to either one of them. The pipe that is not
used must be clogged with the pipe
closer, which added to the appliance.
Use a fixed connections or use a flexible
stainless steel pipes in compliance with
the regulation in force. If you use flexible
metallic pipes, make sure they do not
come in touch with mobile parts and they
are not squeezed.
14.8 Flexible nonmetal pipes
connection
If you have an easy access to the
connection, you can use a flexible pipe.
The flexible pipe must be tightly attached
by clamps.
NORMAL POW‐
ER kW
0.95
GAS RATE g/h
4.0
290.9
3.0
218.1
1.9
138.2
0.95
69.1
REDUCED POWER kW INJECTOR MARK
0.35
REDUCED
POWER kW
1.8
1.1
0.43
0.35
In installation always use the pipe holder
and the gasket. The flexible pipe can be
applied when:
• it can not get hotter than room
temperature, higher than 30 °C,
• it is not longer than 1500 mm,
• it has no narrowing anywhere,
• it is not twisted or tighten,
• it does not get in touch with sharp
edges or corners,
• it's conditions can be easily checked.
When checking the flexible pipe make
sure:
• it does not show cracks, cuts, marks
of burnings on the two ends and on its
full length,
• the material is not hardened, but
shows its correct elasticity,
• the fastening clamps are not rusted,
• expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
WARNING!
When installation is
complete, make sure that
the seal of each pipe fitting
does not leak. To check the
seal use a soap solution, not
a flame.
The gas supply ramp is on the rear side
of the control panel.
ENGLISH
27
1/100 mm
70
INJECTOR MARK
1/100 mm
101o
88
71
50
Advertisement
Table of Contents
