Kohler K-18597 Installation Manual page 10

K-18598, K-18599
Rail
Underside View
Tab
6. Remove the Drawer
NOTE: A release latch is located underneath the front of the drawer
at each corner.
For K-18598 and K-18599
To remove the drawer:
Slide the drawer out on the rails until fully extended.
Pull both release latches toward you, then pull the front of the
drawer up off the rails.
Lift the drawer out from the vanity.
To reinstall the drawer:
Fully extend the rails.
Align the grooves on the underside of the drawer with the rails
and set into place.
Hold the drawer in place on the rails with one hand. With your
other hand, pull the tab on the bottom front of the rail toward
you until you hear the rail "snap" into place. Repeat this step for
the remaining rail.
Ensure the drawer is locked into place by lightly lifting the front
of the drawer upward. If the drawer does not lift up, it is
engaged. If the drawer lifts up, repeat the above procedure.
Slide the drawer in and out of the vanity to ensure smooth
operation.
1055673-2-B
K-18597
Release
Latch
Rail
Release Latch
10
Release Latch
Kohler Co.