Operation Instructions - Black & Decker BDT30WTA Instruction Manual

SET UP & USE

OPERATION INSTRUCTIONS

1. When first operating the dehumidifier, press MODE button, select "continuous"
and allow to run for 24 hours.
NOTE: Unit may shut off automatically during 24 hour period if collection bucket
is full (see below). If continuous drainage mode is utilized, and drain hose
is connected, the unit will operate continuously (see page 12).
2. Press the POWER button once to turn the unit on. Press POWER button again
when you're ready to turn it off.
3. Press the or
humidity in the room. Each press will change the room humidity by 5%. The
room humidity is selectable from 35-80% or continuous. The unit will cycle on
and off to maintain the humidity level chosen on the digital display. If you want
the dehumidifier to operate continuously regardless of the room humidity,
press MODE button until you see "CO" on the display. This will enable
continuous operation and "CONTINOUS" indicator will light up on the control
panel.
4. Press the FAN SPEED button to select between High, Medium and Low. The
selected speed will be confirmed by the indicator on the control panel.
TIMER FUNCTION
To program the unit to automatically turn ON, press the TIMER button when
the unit is OFF. Press
up to 10 hours. After 10 hours, each press of the
hour increments up to 24 hours. Once the desired time is reached, the unit will
automatically turn ON.
To program the unit to automatically turn OFF, press the TIMER button when
the unit is ON. Each press of the
30 minute increments up to 10 hours. After 10 hours, each press of the
buttons will increase or decrease the timer in 1 hour increments up to 24 hours.
Once the desired time is over, the unit will automatically power OFF.
FULL WATER COLLECTION BUCKET
When the water collection bucket is full, the unit will shut off automatically, make
a beeping noise and the BUCKET FULL indicator will light. The dehumidifier will
not run again until the bucket is emptied and properly placed back inside the
unit.
buttons just under the display to select the desired relative
or to increase the timer in 30 minute increments
or
will increase the timer in 1
buttons will change the timer setting in
or
Page 9