Table of Contents
Advertisement
- OR -
Pick up the handset and press the
2. When finished, press
NOTE: Adjust the handset volume by pressing the caller ID-volume (6 or 5) button during a call.
Call Timer
After you press the
TALK or SPEAKER
counts the length of time of the call in minutes and seconds.
Auto Standby
If you place the handset in the cradle while the handset is off the hook (during a call), the call is automatically
disconnected.
Ringer
Volume
There are two ways to set the ringer volume. One is the traditional way as described in the Programming
Functions; Handset Setup; Ringer Volume menus. The other one is this short cut to ringer menu.
1. Make sure the phone is OFF (not in TALK mode).
2. Press the
#pause
button to display SET RINGER
3. Use the caller ID-volume (6 or 5) button to scroll to your selection.
4. Press
#pause
button again to save and display the new selection for a few seconds.
Flash/Call Waiting
If you subscribe to the combined Call Waiting Caller ID service from your local telephone company, you will
receive Caller ID information (if available) on Call Waiting calls. During a phone call, you will hear a beep to
indicate another call is waiting on the line and Caller ID information for the waiting call shows on the handset
display.
• To connect to the waiting call, press the
on hold.
• To switch between the two calls, press the
Last Number Redial
You may redial a number up to digits long. To quickly redial the last number you dialed:
1. Press the
TALK or SPEAKER
2. Press the
redial/format
-OR-
3. Press the
redial/format
number.
- Press the caller ID-volume (5) to review the oldest call and scroll toward the most recent calls (higher
numbers).
- Press the caller ID-volume (6) to review the newest call and scroll to older calls (lower numbers).
NOTE: You may choose from three last dialed numbers.
4. Press the
TALK or SPEAKER
If you get a busy signal and want to keep dialing the number, press the
number.
Exit
Press the
END/cancel
Page
The page feature helps you locate a misplaced handset. To send and receive pages, all handsets must be
registered. If your handset is not registered, follow the instructions in the Registration section of this manual.
Handset to Handset Paging
TALK
button.
END/cancel
to hang up.
button on the handset, the built-in call timer shows on the display and
(Shortcut)
TALK or SPEAKER
TALK or SPEAKER
button.
button.
button first, then use the caller ID-volume (6 or 5) button to select the desired redial
button. The number dials automatically.
button to exit a menu function and return to the standby screen.
(applicable only with additional handsets)
LEVEL
5.
LEVEL 5
button on the handset, and your original call is put
button.
redial/format
is the default setting.
button to quickly redial the
Advertisement
Table of Contents
