Advertisement
• If any error or failure occurs, the FAULT indicator will illuminate and ice
production stops. Please refer to Troubleshooting page.
• Switch off the ice maker and disconnect from power supply when not in use.
• If unit powered off for any reason, please wait at least 3-5 minutes before
powering it back on. This is to protect the compressor.
ICE STORAGE
The ice maker will automatically shut off when the ice storage cabinet is full.
The ice storage cabinet is insulated but not refrigerated.
SOUNDS THE UNIT MAY MAKE
Your new icemaker may make sounds that are not familiar to you. Most of
these sounds are normal. Hard surfaces like the oor or wall can make the
sounds seem louder than they actually are. The following describes the
possible sounds you may expect to hear:
· The high efciency compressor makes a pulsating or high-pitched sound.
· Water running from the evaporator to the water bin makes a splashing sound.
· At the end of each cycle, you may hear a gurgling sound due to refrigerant
owing in the unit.
· Sound of air being forced over the condenser by the condenser fan.
· During the harvest cycle, you may hear ice cubes falling into the bin.
Periodic cleaning and proper maintenance will ensure efciency, performance
and extend unit's life span.
· Always power off and disconnect power supply before cleaning.
· Never use solvent-based cleaning agents, which may leave harmful residues.
· DO NOT wash the main unit, instead wipe the exterior with a damp cloth.
· Dry the interior and exterior with a soft cloth.
· Check the connectors of the water inlet and outlet tubes regularly for leaks.
1. Sanitizing solution - 10:1 ratio of water to vinegar or lemon juice.
2. Wipe the interior, including evaporator rods, with the solution.
3. Remove the water inlet hose and use the same solution to clean the hose.
4. Reinstall inlet hose and run the ice maker
And then drain residue water via drain spout (Part 10 at Page 2)
, discard the rst two batches.
5
Advertisement
