Introduction; Package Contents - Analog Devices Hittite HMC-T2220 User Manual

Synthesized signal generator
Hide thumbs Also See for Hittite HMC-T2220:
Table of Contents

Advertisement

131302 Rev H - v07.0512

1. Introduction

This User's Manual describes the HMC-T2200 Synthesized Signal Generator Family units (SG). Most of the
pertinent information can be quickly located through the table of contents and highlighted sections.
The following conventions and indicators are used in this user's guide:
This indicator calls attention to critical or important information, concerning an operation or
maintenance procedure or practice, which if not strictly followed and observed, could potentially
result in serious injury to operating personnel. An example is the proximity of high AC line voltage.
This indicator draws attention to a situation relating to the equipment set-up, operating or
maintaining the equipment, which if not observed, could result in permanent damage to sensitive
microwave devices or other electronic components.
This indicator highlights a required equipment preparation, fundamental procedure, practice,
condition or statement. Other indicators in bold
of information, input or output connections and signal generator specification headings.
The following nomenclature is affixed to the signal generator front and back panels:
HITTITE MODEL
NUMBER: HMC-T2200 four-digit alphanumeric, front panel.
This user's guide should be thoroughly read in depth and reviewed again completely before
attempting to unpack, install or operate the SG unit.

2. Package Contents

The SG unit and packaging material weigh approximately 8 lbs. Before unpacking, check for any
physical damage to the shipping container. If any noticeable damage is observed, immediately
contact Hittite Microwave Corporation. Carefully open the shipping container and inspect the SG
unit for any visible signs of damage. Save the shipping container to repackage the SG unit, or
for submitting necessary damage claims to the transporter. Remove the documentation packet
and any other separately supplied components before attempting to remove the SG unit from the
shipping container. It is highly recommended as a preventative measure, to exercise antistatic
safeguards when handling the SG unit.
Verify that all of the following components are included with the shipment:
Item
HMC-T2220(B)/40/70 Signal Generator
AC Wall Power Supply
AC Power Cord
CD ROM (Contains User manuals and software)
Calibration Certificate
HMC-T2200 Family Quick Start Guide
LI-ION Battery Packs (HMC-T2220B only)
Order On-Line: www.tm-hittite.com. For technical application questions: Phone: 978-250-3343 or TE@hittite.com
HMC-T2200 Synthesized Signal Generator Family User Manual
Table 1. Packing List
Blue
capital lettering emphasize important points
Quantity
1
1
1
1
1
1
2
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hittite HMC-T2220 and is the answer not in the manual?

This manual is also suitable for:

Hittite hmc-t2240Hittite hmc-t2270Hittite hmc-t2220b

Table of Contents