Connecting The Cables - Matsuko SWITCH BOX Installation And Operating Manual

CONNECTING THE CABLES

WARNING: ALWAYS TURN THE SWITCH BOX POWER
OFF AT THE MAINS ELECTRIC BEFORE OPENING
THE COVER. ALWAYS SECURE WITH CLOSING SCREW.
It is essential for your safety that you ensure the power of all inputs (including mains) is turned
off before proceeding with installation. Do not attempt to install cables without required
knowledge and expertise! Use of a qualified electrician is recommended for all installations.
IMPORTANT: Connect the wires to the appropriate pins (Live,
Neutral, Earth). Up to five outgoing connections can be installed
into the Switch Box (4-8).
Power input is supplied into a separate mains channel (9). Use two
screws to secure the cable grip and fix each cable into place inside
the Switch Box (11). Outside the Switch Box, if using the supplied
cable gland sealing ring, ensure the cable gland sealing ring is
turned clockwise until the cable is firmly secured and sealed in the
connector (10).
Our NEW PCB terminal blocks are
easy click push connectors allowing
the user to connect the power in
and out cables.
8
Use a screw
driver to push
the fastening
clip over on
the terminal
block, place
the cable into
the terminal
block and
release the
clip securing
the cable.
Always
use ferrule
clamps on
the cables to
ensure a safe
connection.