Connecting The Antenna, Cable Or Satellite; Connecting A Set-Top Box, Blu-Ray Disc / Dvd Recorder Via Composite Connectors And Analog Audio; Plugging In The Ac Power Cord - Emerson LD320EM5 Owner's Manual

Connecting the Antenna, Cable or Satellite

Be sure your Antenna or another Device is connected properly before

plugging in the AC Power Cord.

If connecting to an Antenna through an RF cable
Any DTV Programs that are Broadcast in your area can be received for
free through an Antenna Connection.
antenna
IN IN IN
RF cable RF cable RF cable
If you connect a Set-top Box through an RF cable
If the TV is connected to a Cable / Satellite Set-top Box via a Coaxial
Connection, set the TV to channel 3/4 or the channel specified by the
service provider.
antenna
IN IN IN
RF cable
If connecting a Set-top Box through an HDMI cable
If the TV is connected to a Cable / Satellite Set-top Box via an HDMI
cable, make sure you select the correct Source by using SOURCE key on
TV or Remote Control.
IN
HDMI cable
Cable
OUT OUT OUT
RF cable
IN
OUT
Set-top Box
RF cable
IN
OUT
Set-top Box
Connecting a Set-top Box, Blu-ray Disc / DVD Recorder
via Composite Connectors and Analog Audio
Do Not place your Recorder too close to the Screen because some
Recorders can be susceptible to Signals from the TV.
RF cable RF cable RF cable
IN IN IN
IN IN IN
RF cable RF cable RF cable
Video cable + Video cable + Video cable +
Audio (L/R) cables Audio (L/R) cables Audio (L/R) cables
Note(s)
If you have any question about the DTV's Antenna, visit www.antennaweb.org for further
●
information.
Depending on your Antenna system, you may need different types of combiners (mixers)
●
or separators (splitters) for HDTV Signal. The minimum RF bandpass on these Devices is
2,000MHz or 2GHz.
For your safety and to avoid damage to this Unit, please unplug the RF Coaxial Cable from
●
the Antenna Input jack before moving the Unit.
If you did use an Antenna to receive Analog TV, it should also work for DTV reception.
●
Outdoor or attic Antennas will be more effective than a Set-top Box or inside Antenna.
To Turn On your reception source easily between Antenna and Cable, Install an Antenna
●
selector.
If you are not receiving a Signal from your Cable service, contact the Cable provider.
●
Plugging in the AC Power Cord
Make sure All the Necessary Connections are made before the AC Power
Cord is plugged into an AC outlet.
Caution(s)
Do Not connect the AC Power Cord to an AC Power Supply outside the indicated voltage
●
of this Unit (120V AC).
Connecting the AC Power Cord to a Power Supply outside of this range may result in
●
Unit failure, degradation or electrical shock.
Note(s)
Each time you plug in the AC Power Cord, no operations will be performed for several
●
seconds. This is not a malfunction.
13
OUT OUT OUT
Cable
Set-top Box
IN
OUT
OUT
IN
OUT
Blu-ray Disc /
DVD Recorder
Continued on next page.
.
English