Nominal Data; Technical Features; Mounting Data; Transport And Storage Conditions - ebm-papst D4E180-BA04-18 Operating Instructions Manual

D4E180-BA04-18

3.2 Nominal data

Motor M4E068-LA
Phase 1~
Nominal voltage / VAC 115
Frequency / Hz 50
Type of data definition
fa
Valid for approval / CE
standard
-1
Speed / min 1280
Power input / W 310
Current draw / A
2.75
Motor capacitor / µF 30
Capacitor voltage / VDB 220
Min. back pressure / Pa 0
Max. ambient 65
temperature / °C
Starting current / A 6.0
ml = max. load · me = max. efficiency · fa = running at free air
cs = customer specs · cu = customer unit
Subject to alterations

3.3 Technical features

Mass
10 kg
Size 180 mm
Surface of rotor Coated in black
Material of impeller Sheet steel, hot-galvanised
Housing material Sheet steel, hot-galvanised
Direction of rotation
Counter-clockwise, seen on rotor
Type of protection IP 54
Insulation class "B"
Humidity class F3-1
Mounting position Any
Condensate discharge
None
holes
Operation mode S1
Motor bearing Ball bearing
Touch current acc. < 0.75 mA
IEC 60990 (measuring
network Fig. 4, TN
system)
Motor protection Thermal overload protector (TOP) wired
internally
Protection class I (if protective earth is connected by
customer)
Product conforming EN 60335-1; CE
to standard
Approval UL 2111; CSA C22.2 Nr.77
For cyclic speed loads, note that the rotating parts of the device
are designed for maximum one million load cycles. If you have
specific questions, contact ebm-papst for support.
Item no. 11467-5-9970 · Revision 74174 · Release 2011-05-17 · Page 5 / 9
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions
1~ 1~
115 115
60 60
fa fa
CE UL
1320 1320
440 480
3.85 4.05
30 30
220 220
0 0
35 35
5.6 5.6

3.4 Mounting data

For depth of screw, see chapter 3.1 Product drawing
; Secure the mounting screws against accidentally coming loose (e.g.
by using self-locking screws).
Strength class for 8.8
mounting screws
You can obtain additional mounting data from the product drawing if
necessary.

3.5 Transport and storage conditions

; Use the device in accordance with its protection type.
Max. permissible + 80 °C
ambient motor temp.
(transp./ storage)
Min. permissible - 40 °C
ambient motor temp.
(transp./storage)