Attaching Spray Gun - KNOVA KN 9832-G Manual

ASSEMBLY
CAUTION
Oil must be added to unit prior to first use.
To avoid spillage, do not overfill fuel tank as gasoline expands.
ATTACHING THE SPRAY GUN (SEE FIG 4 & 5)
• Screw the spray wand and the trigger handle together until
they are secure.
• Insert the inlet coupler of the spray hose into the threaded
fitting on the high pressure spray gun and thread the black nut
on by turning clockwise until it is hand tight.
Connector
High Pressure hose
CONNECT GARDEN HOSE TO PRESSURE WASHER
(SEE FIG 6)
• Run water through the hose for 30-60 seconds to flush any
debris from the hose.
• Inspect inlet screen and remove any debris.
• Connect hose to water inlet and tighten by hand. There must
be a minimum of 10' of unrestricted hose between pressure
washer and faucet or shut off valve.
Spray Wand
Fig. 4
Inlet Coupler
Fig. 5
• Turn on water.
• Purge the system's pump of air by releasing the safety and
squeezing the trigger of the spray gun.
Water inlet
CAUTION
Do not run pump without connecting to the water supply and
turning water on or damage to the pressure washer could result.
Failure to follow these instructions will void product warranty.
CONNECT HIGH PRESSURE HOSE TO PUMP (SEE FIG 7)
• Attach end of high pressure hose to the high pressure outlet
on pump.
• Follow the same procedure with opposite end to attach high
pressure hose to spray wand.
• Pull back on the quick connect collar to insert a spray tip
(nozzle) in the quick connect fitting.
• Once the nozzle is inserted press and hold it while you release
the collar. Releasing the collar should lock the tip in place.
WARNING
An unlocked tip may cause injury or damage
• Verify that the tip is locked by tugging on the tip before
attempting to spray.
High Pressure hose
7
Screen
Garden hose
Fig. 6
Fig. 7