Advertisement
HOME APPLIANCES
LG STUDIO
LSGS6338F
6.3 cu. ft. Smart wi-fi Gas. Slide-in Range with
ProBake Convection® and EasyClean®
QUICK INSTALL & CLEARANCES
For full installation directions/clearances please refer to
the corresponding User Manual and Installation Guide.
DIMENSIONS / CLEARANCES
INSTALLATION
A Width
B Height
mensions and Clearances
C Depth (Includes Door Handle)
Provide proper clearance between the range and adjacent combustible surfaces.
D Height (Excludes Vent Trim)
E Depth (Includes only the product body that is loaded
These dimensions must be met for safe use of your range.
into the cabinet.Excludes door, drawer, and handles)
The location of the electrical outlet and pipe opening (see "Gas Pipe and Electrical Outlet Locations"
F Depth (Excludes Door Handle)
below) may be adjusted to meet specific requirements.
G Depth when drawer is fully opened
The range may be placed with 0" clearance (flush) at the back wall.
H Depth when door is fully opened
mensions
-
A
Width
B
Height
CONNECTING ELECTRICITY
CONNECTING GAS
Providing Adequate Gas Supply
C
Depth (Includes Door Handle)
•
Your range is designed to operate at a pressure of 5" of water column on natural
D
Height (Excludes Vent Trim)
gas or 10" of water column on LP.
•
E
Depth (Includes only the product body that is loaded into the cabinet.
Make sure you are supplying your range with the type of gas for which it is
Excludes door, drawer, and handles)
configured.
•
This range is convertible for use on natural or LP gas. When using this range on
F
Depth (Excludes Door Handle)
LP gas, conversion must be made by a qualified LP installer before attempting to
G
Depth when drawer is fully opened
operate the range.
•
For proper operation, the pressure of natural gas supplied to the regulator must
H
Depth when door is fully opened
be between 5" and 13" of water column.
•
For LP gas, the pressure supplied to the regulator must be between 10" and 13"
of water column. When checking for correct operation of the regulator, the inlet
pressure must be at least 1" more than the operating (manifold) pressure as
given above.
•
The pressure regulator located at the inlet of the range must remain in the supply
line regardless of which type of gas is being used.
•
A flexible metal appliance connector used to connect the range to the gas supply
line should have an I.D. of 5/8" and a maximum length of 5 feet. In Canada,
flexible connectors must be single wall metal connectors less than 6 feet in
length.
© 2021 LG Electronics USA, Inc. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp. All other product and brand names are trademarks or registered trademarks of their respective owners. Design, features and specifications are subject to
change without notice. Non-metric weights and measurements are approximate. Some features may require Internet access. Content and services may vary by product and are subject to change without notice. 10/11/21
29 7/8"
Minimum
a
37 1/4"
29 3/8"
Minimum clearance to left/right wall
36"
b
24 3/4"
Maximum depth for cabinets above countertops
c
26 7/8"
36 1/16"
Front edge of the range side panel forward from cabinet
d
48 5/8"
To cabinets below cooktop and at the range back
e
Gas Pipe and Electrical Outlet Locations
Dimensions
Leveling
Leveling the Range
Level the range by adjusting the leveling legs with
a wrench. Extending the legs slightly may also
CLEARANCES
1 Minimum
2 Minimum clearance to left/right wall
3 Maximum depth for cabinets above countertops
4 Front edge of the range side panel forward
from cabinet
5 To cabinets below cooktop and at the range back
Clearances
Minimum
a
Minimum clearance to left/right wall
b
Maximum depth for cabinets above countertops
c
GAS PIPE AND ELECTRICAL OUTLET LOCATIONS
Front edge of the range side panel forward from cabinet
d
To cabinets below cooktop and at the range back
e
Gas Pipe and Electrical Outlet Locations
LSGS6338
29 7/8" (758.8 mm)
37 1/4" (946 mm)
CONNECTING ELECTRICITY
CONNECTING ELECTRICITY
Leveling
Electrical Requirements
29 3/8" (745.2 mm)
•
120 Volt, 60 Hz, properly grounded dedicated circuit protected by a 15 or 20
Leveling the Range
36" (913.0 mm)
Amp circuit breaker, or slow blow fuse.
•
Level the range by adjusting the leveling legs with
If an external electrical source is utilized, the appliance, when installed, must be
24 3/4" (629.4 mm)
a wrench. Extending the legs slightly may also
electrically grounded in accordance with local codes or, in the absence of local
codes, with the National Electrical Code, NFPA70 or the Canadian Electric Code,
26 7/8" (683 mm)
CSA C22.1-02.
36 1/16" (916.2 mm)
▲
!
Grounding
•
48 5/8" (1235.9 mm)
For personal safety, this appliance must be properly grounded.
•
Do not, under any circumstances, cut or remove the third (ground) prong from
the power cord.
•
The customer should have the wall receptacle and circuit checked by a qualified
electrician to make sure the receptacle is properly grounded.
POWER/RATINGS
Amp Rating at 240V
30"
5"
13"
1/4"
0"
30"
(76.2 cm)
/
7
14
"
16
30"
(20 cm)
(76.2 cm)
/
11
13
"
16
(30 cm)
/
7
14
"
16
(20 cm)
/
3
6
"
16
(8.5 cm)
/
6
11
"
/
11
13
"
16
16
(30 cm)
(17 cm)
3
6
/
"
3"
16
/
17
"
15
(8.5 cm)
16
6
/
"
11
/
(7.6 cm)
5
14
"
16
16
(45.6 cm)
(17 cm)
(15 cm)
3"
/
17
15
"
16
(7.6 cm)
5
14
/
"
(45.6 cm)
16
(15 cm)
make it easier to insert the rear leg into the anti-t
make it easier to insert the rear leg
bracket.
bracket.
44.2A (120VAC, 60Hz)
INSTALLATION
Advertisement
