Starting The Programme; Adjusting The "Ready In" Time Before The Programme Starts; Soaking Laundry; Adding Laundry - Bosch WUU28T6XES User Manual And Assembly Instructions

Push in the detergent drawer.
4.

Starting the programme

Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Inicio/Pausa + Carga
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
Press Inicio/Pausa + Carga
1.
Press Termin.
2.
the display indicates the desired
"Ready in" time.
Press Inicio/Pausa + Carga
3.

Soaking laundry

You can soak the laundry before
washing in the appliance by pausing
the programme.
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Inicio/
Pausa + Carga
To resume the programme, after
3.
the desired soaking time, press
Inicio/Pausa + Carga
.
.
repeatedly until
.
.
.

Adding laundry

Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Inicio/Pausa + Carga
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
Add or remove laundry.
2.
Close the door.
3.
Press Inicio/Pausa + Carga
4.

Cancelling the programme

Once the programme has started,
you can cancel it at any time.
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Inicio/Pausa + Carga
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the programme.
– If the water level is high: Start
the or
Remove the laundry.
3.
Resuming the programme
when the programme status
is Rinse Hold
Set the or
1.
Press Inicio/Pausa + Carga
2.
Basic operation en
programme.
programme.
.
.
.
.
37