Canon 10 Instruction Manual page 74

❍ The red-eye reduction mode cannot be used in stitch assist mode.
❍ The flash cannot be used in Night and Super Night (OPTURA20) mode.
❍ The flash will not fire in the following cases:
- When you press the EXP button in [AUTO
E
- When a shutter speed of 1/2000 or faster is set in CAMERA mode (the flash
mark appears in purple). However, if [FLASH ON
of the selected shutter speed flashes in purple for 4 seconds and the shutter
speed becomes set to 1/1000; the flash fires.
- When an abnormality occurs during charging (the flash mark flashes in red).
- When the multi-image screen is selected or when you are recording movies
onto a tape (no flash mark appears).
- When the flash mark does not appear in green when you press the PHOTO
button. Set it to [FLASH ON
❍ When the flash is fired with an accessory such as an optional tele-converter
attached to the camcorder, its shadow may be recorded.
❍ An image recorded with flash may flicker when played back on a different
device.
Using the Video Flash Light as Video Light
CAMERA
1. Set the camcorder to CAMERA or CARD CAMERA mode.
2. Set the video flash light's POWER switch to
• (Connection) appears.
• ON: The video light stays on.
• AUTO: The video light turns on and off automatically.
❍ Do not touch or place flammable material or plastic close to the lamp or the
surrounding parts during or immediately after use; they become very hot.
❍ Do not look directly at the lamp while the video light is on.
74
] if necessary.
PLAY (VCR)
] or [RED-EYE
] is selected, the display
CARD CAMERA
AUTO or
] mode.
CARD PLAY (VCR)
ON.