Batteries, Insert; Connect - Philips VOIP3211S/90 User Manual

Table of Contents

Note : Install the drivers and software first (see page 11) and

connect the USB phone only once it is done.

Connect the output plug of the base adapter to the adapter socket on

the back of the base unit and the base adapter to the wall main supply.

A click should be heard when the cord is properly connected to the

base.

Connect the USB plug directly to your PC's USB slot.

Connect the telephone line cord to the phone socket on the back of

the base unit and to the plug (optional and country dependent) then

to the wall phone socket.

Note : You may find in the box the line adaptor delivered separately

from the line cord. In this case, please, first plug this line adaptor onto

the line cord before connecting it to the line socket.

Each handset comes with a charger and an adapter. Connect the

adapter to the wall main supply.

Place the 2 rechargeable NiMH AAA batteries (included), observing

their polarities, into the battery compartment on the handset.

Slide the battery door firmly into place.

Place the handset on the charger and let the batteries continuously

charge for 24 hours before using. The handset may get warm during

the initial charge. This is normal.

Please note that handset may not turn ON for up to 15 minutes if the

batteries are too low.

Note : Before first use, put the product on the charger and charge

batteries for 24 hours minimum.

Table of Contents