Stopping Engine; Blower Operation - Echo SHRED N VAC ES-231 Operator's Manual

STOPPING ENGINE

1. Throttle Trigger/Throttle Position Lever
Release throttle trigger (F). Move throttle position lever (B) forward
to idle position and allow engine to return to idle before shutting
engine off.
2. Stop Switch
Move stop switch (A) to "STOP" position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.

BLOWER OPERATION

WARNING
Always wear safety glasses, hearing protection and a face filter
mask or serious personal injury may result. Do not point the blower
pipe in the direction of people or pets. Never operate unit without
either housing cover grill or vacuum tube installed on unit securely,
otherwise bodily harm may result.
Read the Safety Section carefully.
IMPORTANT
To avoid engine damage due to over-revving, do not block blower
pipe.
1. Use only during appropriate hours.
2. Allow the engine to warm up at a fast idle for a few minutes.
3. Control engine speed with throttle trigger (A), or for continuous
use, set engine speed with throttle position lever (B). Rotate throttle
position lever forward for lower speed, back for higher speed.
4. Use lower speed to blow debris from hard surfaces.
5. Additional speed may be necessary to clean debris, snow, etc. from
lawns and flowerbeds.
NOTE
Never use a higher speed setting than necessary to perform a task.
Remember, the higher the engine speed, the louder the blower
noise. Minimize dust by using blower at lower speeds. Keep debris
on your property.
Be Smart - be a good neighbor.
DANGER
DANGER
S 'N' V
HRED
O ' M
PERATOR S ANUAL
A
B
B
®
AC
13
F
A