Faults And What To Do About Them - Bosch WAWH26I9SN Instruction Manual And Installation Instructions

Faults and what to do about them.

Faults
Water is leaking from the
machine.
The appliance is not
filling with water.
Detergent is not being
dispensed.
The dispenser is empty
and the fill level indicator
is not flashing.
The wrong detergent/
fabric softener has been
poured into the
dispenser(s).
Detergent/fabric softener
has congealed in the
dispensers.
The door will not open.
The programme will not
start.
The drum briefly jerks or
judders after the
programme has started.
The water is not draining.
Water is not visible in the
drum.
The spin result is not
satisfactory.
Laundry wet/too damp.
The appliance restarts
the spin cycle several
times.
Cause/remedy
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the supply hose.
■
Have you pressed the A button?
■
Is the tap turned on?
■
Could the filter be clogged?Clean the filter.~ Page 58
■
Is the supply hose kinked or trapped?
■
Is the drawer cover/connector dirty? Clean the detergent drawer.
■
~ Page 56
Has the detergent drawer been pushed in correctly? ~ Page 44
■
Dispenser(s):
1. Empty and clean. ~ Page 56
2. Refill. ~ Page 44
Clean and refill the dispensers.
The safety function is activated. Stop the programme? ~ Page 42
■
Is the E childproof lock activated? Deactivate it. ~ Page 42
■
Is $ selected (Rinse Stop = no final spin)? ~ Page 42
■
Can the door only be opened by the emergency release? ~ Page 59
■
Have you pressed the A button or selected Ready in time?
■
Is the door closed?
■
Is the E childproof lock activated? Deactivate it. ~ Page 42
■
If ù is flashing, the detergent drawer has not been pushed in fully. Push
■
the drawer in correctly.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
Is $ selected (Rinse Stop = no final spin)? ~ Page 42
■
Clean the drain pump. ~ Page 57
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Not a fault – the unbalanced load detection system has interrupted the
■
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbalance.
Faults and what to do about them.
en
61