Table of Contents
Advertisement
User manual Prestigio Multiboard
Startup/Shutdown
• Startup/shutdown
Use 100-240V AC as the power supply.
on the panel and the remote control can be used to switch between power-on and
standby states.
product; press the I end to power it on.
• Auto standby
In the Android main interface, whether there is signal input or not, the product will not
enter the standby mode.
In the non-Android main interface, if there is no signal input within 15min, the product
will automatically enter the standby mode.
• Save before shutdown
Before shutdown, the product will save the picture and sound settings. Upon restart,
these settings will be used.
• OPS ON/OFF
If the product is installed with the OPS module and it is in OPS signal source, the OPS
module will start automatically. If not, start it manually.
Before turning off the product, first use the touch function or mouse to turn off the
OPS module from the Start menu. The Standby key on the panel or remote control can
be used to turn off the product only after the OPS module completely shuts down. It is
not allowed to press the Standby key or directly disconnect the power supply without
turning off the OPS module as it will damage the OPS module.
When the OPS module enters the OFF state and no operation is performed on the PC
for a long period of time, this product will enter standby. To use the module, just
restart the product.
Note: The OPS module is optional.
Sidebar Setting
Press the sidebar shortcut key arrow, or slide the edge of the screen inwards (when
turn off the touch signal switch) to tune out the sidebar menu that are respectively
system setting, signal source/menu setting, small tools, progress management, switch
to Android homepage, return and comments.
Signal Source Switching
You can use the remote control or touch function to switch the source by the following
methods:
Method one: press the "Signal Source" key on the remote controller to call "Signal
Source Menu", press the cursor key on the remote control to select a
signal source, press the "OK" key, and then the product will switch to
the input signal source that you selected.
on the rear panel has two ends. Press the O end to power off the
EN - 12
Advertisement
Table of Contents
