Installation And Setup; Before You Begin - Motorola GX2 EA1000C Series User Manual

Installation and Setup

3
This section provides instructions on how to install the GX2-EA1000C*/*, connect it to
other equipment, select the operating mode, and verify its operation. To function, the
GX2-EA1000C*/* requires a GX2-HSG* equipment shelf configured with a
GX2-PSAC10D-R or GX2-PSDC10D-R power supply and a GX2-CM100B control module.
These modules are shipped with documentation; follow the installation instructions in
each manual to populate the GX2-HSG* equipment shelf.
Installing the GX2-EA1000C*/* in the equipment shelf requires:
•
Unpacking the GX2-EA1000C*/* and recording the model number, serial number,
and other related information
•
Installing the RF interface connectors on the rear of the GX2-HSG*
•
Cleaning the GX2-EA1000C*/* optical bulkhead and interface fiber connectors
•
Inserting the optical interface connector in the GX2-EA1000C*/*
•
Installing the GX2-EA1000C*/* in the GX2-HSG*
•
Powering up and initializing reset
•
Measuring and checking the optical output power
•
Measuring and checking the input signal levels
•
Implementing the GX2-EA1000C*/* MGC and AGC operating modes
D A N G E R !
OmniStar GX2 application modules can be damaged by electrostatic discharge (ESD). The use
of an appropriate wrist ground strap is strongly recommended. A ground connection is
provided on the front of the GX2-HSG*.

Before You Begin

Before performing the installation, acquire a fiber maintenance kit (Alcoa Fujikura part
number C008812, ACT-1, or equivalent). See the instructions to properly use the kit. The
following items are required for proper fiber maintenance:
•
99% isopropyl alcohol
•
Lint-free, anti-static wipes
•
Compressed, filtered air
•
Lint-free swabs
GX2 EA1000C*/* Multi-Wavelength DWDM 1550 nm Laser Transmitter • User Guide
589569-001-a
Installation and Setup
B
17