Table of Contents
Advertisement
GROUNDING
DOUBLE INSULATED TOOLS: TOOLS WITH TWO PRONG PLUGS
1. Tools marked "Double Insulated" do not
require grounding. They have a special double
insulation system which satisfies OSHA
requirements and complies with the applicable
standards of Underwriters Laboratories, Inc.,
the Canadian Standard Association, and the
National Electrical Code. (See Figure B.)
2. Double insulated tools may be used in either
of the 120 volt outlets shown in the following
illustration. (See Figure B.)
EXTENSION CORDS
Use only accessories that are recommended by
the manufacturer for your model. Accessories
that may be suitable for one tool may become
hazardous when used on another tool.
Always attach grounded (3-prong) extension
cords to grounded (3-hole) outlets. If you must
CONTROLS AND COMPONENTS
1. Three (3) Setting Power Switch
2. Temperature control buttons
3. Power Cord
4. Air intake
6
use an extension cord, be sure that the gauge
is large enough to carry the amount of current
necessary for your power tool. If not, your tool
may experience a loss of power, excessive volt-
age drop or overheating. The smaller the gauge
number, the heavier the cord (see table below).
4
2
1
Figure B
3
Advertisement
Table of Contents
